To clear the check engine light, turn the ignition to the on position (without starting the engine) and press the gas pedal 5 times within 5 seconds. Wait 5 seconds and turn the ignition off. Turn the ignition back on and the check engine light should be off.
To clear the check engine light, turn the ignition on and off three times, with 5 seconds in between each turn. Then, drive the car for 10-15 minutes to allow the computer to re-set.
How to clear reduced engine power code
1. Turn the ignition key to the On position without starting the engine.
2. Press and hold the gas pedal to the floor for 5 seconds.
3. Turn the ignition key to the Off position.
4. Start the engine and drive the vehicle.
Connect the scanner to the OBD-II port, turn the ignition on, and select the “Read Codes” option. The codes will be displayed on the scanner’s screen. To clear the codes, select the “Clear Codes” option.
Connect the code reader to the OBD-II port under the steering wheel. Turn the ignition on, but don’t start the engine. The code reader will display the codes. Clear the codes by pressing the erase or reset button.
To clear the check engine light on a Polaris RZR, turn the key to the on position without starting the engine. Press and hold the gas and brake pedals for five seconds. Turn the key off and then on to start the engine.
1. Turn the ignition key to the “On” position without starting the engine. 2. Press and hold the gas pedal and the brake pedal at the same time for 5 seconds. 3. Turn the ignition key to the “Off” position. 4. The check engine light should be cleared.
Turn the ignition on and off 3 times. The Check Engine light will flash a series of codes. Each code is a number, pause, then a letter.
How to Check Your Engine Code
1. Turn the ignition key to the ON position without starting the engine.
2. Press the gas pedal 3 times quickly.
3. The check engine light will flash a series of numbers.
4. Write down the numbers in the order they flash.
5. Look up the numbers in your car’s owner’s manual to find out what they mean.
1. Turn the ignition to the ON position without starting the engine.
2. Press and release the gas pedal 3 times within 5 seconds.
3. The check engine light will flash 10 times, followed by a 5-second pause.
4. Each flash of the check engine light represents a different digit in the diagnostic trouble code (DTC).
5. Write down the DTCs in order from left to right.
6. Use a DTC lookup table to identify the meaning of the codes.